| Vacuum Industries
Sintervac 40
De-Wax Carbide Sintering Vacuum Furnace Model 8820, Vacuum
Furnace with:
Graphite Heating Elements w/ Graphite felt Insulation
Effective Hot Zone 8" x 8" x 20"
Maximum Operating temperature : 1600 °C .
Stainless Steel Inner, Carbon Steel Outer , Water jacketed
Chamber with cooling Fan, Wax Condenser, (USED)Stokes Vacuum
Pump Model 149 , 480V, 60 Hz, 3Ph Eclipse Digital Programmable
Controller ,High Temp thermocouple Digital Read out Amp/ Voltage
Meters, Vacuum Gauge and Hastings Digital Vacuum Controller,60
KVA Power Transformer 440 Volt/3Ph/60Hz. Water manifold
connection and gauge.
Note: This furnace is offered
"AS IS WHERE IS CONDITION" with no warranties on any components,
cleaned and painted. The following items were purchased NEW
and are included with the furnace.
1.(1ea.)Graphite hearth plate, 8" wide x 24" lg. X .25" thk
2. (2ea.)Hearth post with step, 2.88" lg. X .44" dia.
3. (6ea.)Hearth post without step , 2.88" lg. X .44"dia.
4.(4ea.)Water-cooled power cables, new style, with male
connectors, 3/8" NPT to ˝ compression
(4ea.) male elbow connectors 3/8" NPT to ˝" compression.
5. (1ea.)Front door O-Ring , .275" dia x 69" lg.
6. (1ea.)O-Ring for rear fan flange 2-448
7. (1ea.)O-Ring set for power feedthru as follows:
A. Qty. 4 buna O-ring 2-239 to seal Nylon flange to chamber
B. Qty. 4 Buna O-Ring 2-210 to seal electrode in nylon flange
C. Qty. 4 Buna O-Ring 2-214 to seal electrode in water header
8. (4ea.) Element support rod clevis
9. (1ea.) Graphite pin 1/4" dia x 12" lg.
10.(1ea.) Graphite cement kit C34, ˝ pint of powder ˝ pint of
liquid
11.(4ea.) Alumina insulator , 1 3/8" ID x 1 ˝" OD x 2 ˝" Lg.
12.(2ea.) Graphite Heating Elements
13. New instruction Manual for Job-4-5197, also includes
electrical drawings & mechanical assembly drawings,
No fabrication drawings or components manuals. |
